CensusTransformInImageProcessing

语音识别预处理matlab实现，包括端点检测，预加重，加窗(Speech recognition pre matlab implementation, including endpoint detection, pre-emphasis, windowing)

说明：  这是一个用matlab编写的基于实数遗传算法程序，汉语注释详细，绝对原创。运行结果正确。(This is a prepared using matlab genetic algorithm based on real process, detailed notes in Chinese, is absolutely original. The correct results.)

matlab编写的三维FDTD程序 pml边界条件 实现电磁波传播数值模拟和仿真(Matlab prepared by the three-dimensional FDTD procedures pml boundary conditions to achieve numerical simulation of electromagnetic wave propagation and Simulation)

Matlab documentations in French

MATLAB软件对不同发射天线、不同接收天线、不同信噪比下的MIMO系统容量进行仿真，得出在不增加带宽和天线发送功率的情况下利用MIMO信道成倍地提高无线信道容量(MATLAB software for different antennas, different antenna, different SNR of the MIMO system capacity for simulation, obtained without increasing the bandwidth and the antenna transmit power where the use of MIMO channels to improve wireless channel capacity multiplied)

本文档是一个相关函数与协方差函数的计算函数(This document is a correlation function with the covariance function calculation function)

三相交流电矢量叠加仿真,自动调平衡补偿，完全始创，难得哦(three phase )

本程序是运用小波分析和神经网络结合方法进行风速预测(This procedure is the use of wavelet analysis and neural network approach to predict wind speed)

把激光陀螺捷联惯导系统和GNSS接收机固联于实验车实验仓中，接收机天线固联在实验车实验仓上方，车载计算机实时接收和采集惯导系统、卫星导航接收机的原始数据，在郊外开阔公路进行车载实验。 通过matlab编程实现卫星导航伪距单点定位、INS/GPS松组合导航的全过程。 1）卫星导航单点定位测速：利用采集得到的接收机时间、伪距、多普勒频移数据，要求进行单点定位、测速解算，输出接收机的位置、速度随时间的变化曲线，并给出位置、速度误差曲线； 2）松组合导航：结合惯导解算和卫星接收机单点定位测速，要求采用Kalman滤波器实现惯导/卫星位置、速度组合导航解算，滤波器维数至少包括惯导的位置、速度、姿态角9维。将组合导航后的姿态角与纯惯导的姿态角进行对比分析，给出位置、速度误差曲线。(The laser gyro strapdown inertial navigation system and GNSS receiver are fixed in the experimental compartment of the experimental vehicle. The antenna of the receiver is fixed above the experimental compartment of the experimental vehicle. The on-board computer receives and collects the original data of the inertial navigation system and satellite navigation receiver in real time, and carries out on-board experiments on the suburban open highway.)

说明：  一个关于考虑铁损的感应电机用M语言写的模型，输出为电流等十六个参数。(1 on the induction motor considering iron loss of the written language with the M model, the output current of 16 parameters.)