一个非常完整的川口通讯源程序，我费了很大功夫才把他找到。...

win2000下的与下位机UART的串口通信程序-WIN2000 with the crew under the UART serial communication program

用C++写的RS232串口异步通讯功能模块，支持16550 UART芯片，中断收发数据，波特率最大115200bps，自定义收发数据缓冲大小，支持软硬件流控。-C wrote asynchronous RS232 serial communication module, 16550 UART chip, Transceivers interruption data, 115,200 bps maximum baud rate, since the definition of sending and receiving data buffer size, support hardware and software flow control.

C++Builder 串口编程的很好的控件包，有必要用ＢＣＢ编写的同仁不防下载试用．-C Builder Serial Programming good control packet, it is necessary to prepare the BCB colleagues not anti-downloading trial.

The EZ320 utility demonstrates the communication program between host PC and the MR320.

pc端用并口来模拟IIC串口的驱动程序，-programe for IIC host

使用说明： 系统要求：WIN9X/ME/NT/2000 VC++6.0 且安装了VC ACTIVEX控件（在VC6安装时选上） 免费 简介：在VC++6.0中用MSComm控件编程，可以实现串口接收数据和发送数据，数据分别显示在接收框和发送框中。-Usage: System Requirements: WIN9X/ME/NT/2000 VC++ 6.0 and installed VC ACTIVEX controls (in VC6 installation selected) Free Introduction: In VC++ 6.0 using MSComm control programming can be achieved Serial receive data and send data, data were displayed on the receiver box and sent box.

一个基于VC++的串口通讯的 小程序，有代码。可以作为串口通讯编程的入门程序。也可作为研究用。-a VC-based serial communications small program code. As serial communication programming entry procedures. Also can be used as research.

这是一个GPS芯片的程序，能够读取各种GPS信号，采用串口通信，能够准确地定位地理信息-This is a GPS chip procedures, be able to read a variety of GPS signal, using serial communications, be able to accurately geo-positioning information

云台镜头控制系统 很好用，调试通过，大家一起分享源代码-pan and camera control system is useful, debugging through, we share source code

getmywish结合visual basic60和msdn帮助，编写了一个两个串口的受到发送程序，该程序在win98,win2000,winxp下调试通过，希望和大家工勉-getmywish combine visual and VARIANT basic60 help prepared a two Serial sent by the program, which in win98, WIN2000. Debugging under winxp passed, and we hope that the Mian