C and ASM development of the mixed

用硬件协议栈芯片w3100a实现tcp服务器，用51单片机实现 kei51环境-hardware protocol stack chips w3100a achieve tcp servers, with 51 MCU environment kei51

AVR单片机对DS1631温度传感器的控制程序。包括了对DS1631的操作子程序等-AVR right DS1631 temperature sensor control procedures. The DS1631 includes the operation of such Subroutine

c51单片机实现GPS数据接受并通过数码管显示时间-c51 achieve single-chip GPS data receive and display digital time

周立功DP51+试验板程序-weeks meritorious DP51 plate test procedures

FlashFlex51微控制器

用C51实现的拼音输入法,这是改写的网友 embuffalo、独步上载在www.21ic.com自由发布区的由张凯原作的51上的拼音输入法程序。 原作使用了一个二维数组用以查表，我认为这样比较的浪费空间，而且每个字表的索引地址要手工输入，效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。 因为代码比较的大，共有6,000多汉字，这样就得要12,000 byte来存放GB内码，所以也是没办法的 :-( 编译结果约为3000h,因为大部分是索引表，代码优化几乎无效。 在Keil C里仿真芯片选用的是华邦的W77E58，它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限，没有上片试验，仿真而已。 打算将其移植到AVR上，但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样，现在还未搞定。还希望在这方面有经验的网友能给予指导。-C51 with the Pinyin input method, which is rewritten netizens embuffalo. Unrivaled www.21ic.com available in the free publication of the original work by Kai-51 on the Pinyin input method procedures . Appreciate the use of a two-dimensional array for the look-up table, I think this is a waste of space. Each of the characters but the index table to manually input address, efficiency is not high. I use the structure to rewrite a bit. We see now is this. Because the code comparison, a total of 6, more than 000 Chinese characters, this must

基于51系列单片机实现8字数码管对时钟秒表的显示-MCU eight characters of the digital clock shows the stopwatch

simpliciti1.0.4版本，在CC2430上通过实验-simpliciti1.0.4 version, the CC2430 on the experiments

mcs-51 单片机编程实用程序-mcs-51 Programming Utility

51单片机学习原代码经验丰富工程师编写实际运行通过-51 Single-chip learning the original source of experienced engineers to run through the preparation of the actual