程序用C51实现： 单片机对LCD1602的控制显示 采用总线方式

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

一个在单片机平台的电梯模拟程序，基本实现了电梯的所有基本功能，可供学单片机的同学参考。本程序使用VHDL语言编写。-A single-chip platform in the elevator simulation program, the basic realization of the elevator all the basic functions, for school students Singlechip reference. This procedure using the VHDL language.

USB转lpt 68013 驱动方案 USB转lpt 68013 驱动方案-Lpt 68013 Driver USB to USB transfer program lpt 68013 driver program

基于16位单片机的符合osek标准的操作系统，在freescale的16位单片机上调试通过-Based on 16-bit MCU line with the OSEK operating system standard, in the Freescale 16-bit single-chip debugging through

研究了两周的IAP，其中实现了在c++中调用c函数的功能，仅供参考-two weeks of the IAP, which met the call c c of functionality, for information purposes only

EMC的开发库 是单片机性价比高的选择 提高快速开发-EMC microcontroller development libraries are cost-effective option to enhance rapid development of high

单片机C8051加无线模块nRF24L01实现温度传感器数据采集和无线收发（接收部分）-C8051 MCU plus wireless module nRF24L01 to achieve the temperature sensor data acquisition and wireless transceiver (receiver part)

十五路遥控接收板-15 road remote control receiver

HCS08的AD例程：本程序是ADC模块的例程，所用资源为单片机内部ADC转换模块， 所接器件为电位器.-HCS08 s AD routine: This is the ADC module of the routine procedure, the use of resources within the ADC conversion for the microcontroller module, the device is connected potentiometer.

Ti 公司低功耗RF芯片选型资料.其中有13.56-27MHz,300-1000MHz ,2.4GHz等等芯片选型参考-Ti low-power RF chip companies Selection information. Among them, 13.56-27MHz ,300-1000MHz, 2.4GHz chip, etc. Selection of reference