c language pinyin input method to achieve very good.

基于单片机的网络通讯，代码优化简洁。 适合一般网络通讯的参考。-Based on single-chip network communications, code optimization concise. Network communications for general reference.

debussy中文使用手册，可以追踪源代码调试，验证的必要工具，只要解压缩即可-Chinese user manual tracking source code debugging, verification of the necessary tools decompression can be as long as

用C51编写的电热水壶C51程序，附详细的代码，测试通过，放心使用，请认真参考-C51 with C51, prepared by Electric Kettle procedures, with detailed code, test, ease of use, please give serious consideration to

This version of the code is compatible only with the AT89C2051 due to the location of the data buffer and stack in RAM. The code may be modified to work with the AT89C1051 by relocating or resizing the buffer and stack to fit into the smaller amount of RAM available in the AT89C1051.

单片机串口程序，可以通过keil编译，实现一台主机和多台从机的通信，从机挂接同一条总线,主机对通信有决定权 -MCU procedures, Keil compiler can achieve a host and multiple communications from the plane, from the plane with an articulated bus, the mainframe has the right to decide Communications

c8051f330 ad 测试程序代码 -F33x_ADC0_ExternalInput

RS485的C51程序 中断 寄存器设置 接收和发送数据，希望对大家有用-RS485 interrupt register of the C51 program set to receive and send data, in the hope that useful

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

关于温度传感器的内容,已经调试成功的,应该OK,希望有帮助啊 -Temperature sensor on the content, have been debug successful, it should be OK, hope that has helped ah

我写的C8051F02x的一部分模块库，目前是OSC和UART的-I wrote part of C8051F02x module library is currently the OSC and the UART