ucosz在2407上的移植代码

UCOS-II FOR STM32F103XX 1 本程序是我自己移植，只使用KEIL进行过软仿真，测试没有发现问题。支持从任何一个中断服务程序里释放信号量。 2 此代码作为参考和学习使用，如果在使用过程中造成损失，本人不负任何责任。 3 此代码作为参考和学习使用，因为里边有UCOS-II，如果要作为商业使用请给UCOS付费。-UCOS-II FOR STM32F103XX 1 This procedure is my own transplant, carried out using only soft KEIL simulation, testing did not find the problem. Support from any one of interrupt service routine release semaphore. 2 of this code as a reference and learning to use, if in the use of the process of loss, I no responsibility. 3 of this code as a reference and learning to use, because inside has UCOS-II, if we as a commercial use, please pay uCOS.

介绍了ucos在ARM上移植过程与注电事项-Describes the ucos the ARM note on the migration process and electrical items

最初学习单片机的时候，由于条件，没有硬件，就只好用Proteus仿真，其实效果蛮不错的。到后来的高版本，直接可以支持ARM。相当不错的工具。此源码是其对uCOS在ARM上运行的仿真。-MCU when the initial study, due to conditions, not hardware, they can use Proteus simulation, in fact, quite a good effect. Later versions of the high direct support ARM. Pretty good tool. This source is its uCOS running in ARM emulation.

Can总线的控制协议，主要是用来实现以Can总线协议的方式进行的数据传输-Can Bus control protocol is primarily used for Can bus protocol in order to realize the way the data transmission

基于 Philips 公司的 ARM-7 使用之 uC/OS-II 作业系统,此例程是移植于 LPC-2138 上的应用,不同于一般的 Porting 其最主要是加入了支援 OS_View 观察器功能,于 IAR EWARM V4.41A 工程编译,而 uC/OS 版本为 2.83-Based on the Philips company

嵌入式操作系统UCOSII文件系统使用手册(Embedded operating system file system user manual UCOSII)

在KEIL下使用UCOS来编写程式，还不错(in UCOS KEIL use to write programs, but also good)

该代码在KEIL平台基础上实现LPC2132与MAX485进行RS485通信-The code in KEIL platform based on the LPC2132 with the MAX485 for RS485 communication

三星开发板S3C44B0的经过移植的启动程序。可以用EMBEST IDE PRO编程。-Samsung development board S3C44B0 after transplantation of the commencement of proceedings. IDE can be used EMBEST PRO programming.

uCOS-II2.83程序 UCOS源码大全，集合了ucos的很多源码和功能 -uCOS-II2.83 procedures Guinness uCOS source, bringing together many of uCOS source and function