智能吊车，广西壮族自治区电子设计踢 得一等奖

lcd12864 带字库的驱动程序 不看后悔-lcd12864 with a font driver Bukanhouhui

51系列单片机的OCM12864液晶显示程序。初学单片机。-51 Series LCD OCM12864 SCM procedures. Singlechip beginner.

本文介绍了ISP程序设计方法，以及在SST和STC单片机上的具体实现方法-This paper introduces the ISP programming method, as well as in the SST and the STC on the concrete realization of single-chip approach

是一个为地铁施工现场开发的人数监控系统，使用ATMEGA16单片机做的，并用了红外传感器。-Is a subway construction site for the development of the number of monitoring systems, using ATMEGA16 microcontroller to do, and use the infrared sensor.

低频信号发生器的使用低频信号发生器的使用-The use of low-frequency signal generator of the use of low-frequency signal generator

座机电话短信发送源代码，座机按键号码获取，以及分类应用！-ace telephone messages this source code, ace number keys acquisition, classification and application!

用C51实现的拼音输入法,这是改写的网友 embuffalo、独步上载在www.21ic.com自由发布区的由张凯原作的51上的拼音输入法程序。 原作使用了一个二维数组用以查表，我认为这样比较的浪费空间，而且每个字表的索引地址要手工输入，效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。 因为代码比较的大，共有6,000多汉字，这样就得要12,000 byte来存放GB内码，所以也是没办法的 :-( 编译结果约为3000h,因为大部分是索引表，代码优化几乎无效。 在Keil C里仿真芯片选用的是华邦的W77E58，它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限，没有上片试验，仿真而已。 打算将其移植到AVR上，但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样，现在还未搞定。还希望在这方面有经验的网友能给予指导。-C51 with the Pinyin input method, which is rewritten netizens embuffalo. Unrivaled www.21ic.com available in the free publication of the original work by Kai-51 on the Pinyin input method procedures . Appreciate the use of a two-dimensional array for the look-up table, I think this is a waste of space. Each of the characters but the index table to manually input address, efficiency is not high. I use the structure to rewrite a bit. We see now is this. Because the code comparison, a total of 6, more than 000 Chinese characters, this must

单片机键盘MakeKey编程-microcontroller programming keyboard MakeKey

单片机控制的12864液晶显示器的驱动程序,通过按键控制-MCU control of the 12,864 LCD driver, through the control button

凌阳的液晶驱动 61板，大家自己看看吧-Sunplus LCD driver 61 boards, we could see for himself now