programmable microwave systems, at89c52 MCU Series

C51单片机做的驱动四线程马达的驱动程序,用于步进电机驱动!-C51 microcontroller do drive four threads motor driver for stepper motor drives!

C51的tcpip源程序 包含了TCP,IP,ARP,ICMP等协议的接口，可以方便的实现移植。开发环境为Keil C51。-tcpip programme for C51

基于单片机c8051f020的模数转换，数模转换应用实例-C8051f020 based on single-chip analog-to-digital conversion, digital-to-analog converter application

在现代电子系统中，有为数众多的IC需要进行相互之间以及与外界的通信。为了提供硬件 的效率和简化电路的设计，PHILIPS开发了一种用于内部IC控制的简单的双向两线串行总线I2C-In modern electronic systems, there are a large number of IC need each other and communicate with the outside world. In order to provide the efficiency and simplify the hardware circuit design, PHILIPS developed an IC for internal control, a simple bi-directional two-wire serial bus I2C.

电感电容表,用2051作CPU,用1602作显示-Inductance capacitance table, using 2051 for the CPU, by 1602 for display

单片机atmega16内部模数转换程序，功能：通过调节ADC0、ADC1两个电位器来改变输入电压，并在数码管同时显示两路电压值。-SCM atmega16 internal analog-digital conversion procedure, function: by adjusting the ADC0, ADC1 two potentiometers to change the input voltage, and also showed two-way digital control voltage value.

温度传感器LM75测试c语言程序（带串口发送程序）-LM75 temperature sensor test c language program (with Serial Send procedure)

用于MSP430F247单片机的NOKIA5110液晶屏驱动程序-NOLIA 5110 LCD Driver For MSP430F247

单一灯的左移右移分别接在单片机的P1.0－P1.7接口上，输出“0”时，发光二极管亮，开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮，重复循环-A single light, respectively, shifted to right then left at P1.0-P1.7 microcontroller interface, the output " 0" when the bright light-emitting diode, the beginning of P1.0 → P1.1 → P1.2 → P1. 3 → ┅ → P1.7 → P1.6 → ┅ → P1.0 Liang, repeat cycle

STC单片机说明,与传统51比较,方便替代习惯于传统51的编程-STC Singlechip shows that compared with the traditional 51 to facilitate alternative programming accustomed to the traditional 51