利用8279芯片实现通过2X8键盘输入加数和被加数并计算出结果，同时将加数、被加数和结果都在LED灯上显示出来。...

对家用电扇进行模拟控制，实现自然，正常；快中慢的转换，用8086实现和用直流电机进行模拟实现，附程序-Analog control of the home fans to achieve a natural, normal fast in the slow conversion, with the 8086 implementation and the use of DC motor to simulate to achieve, with a program

一个很不错的按键单片机C程序-a very good button SCM C Program

基于STC5410单片机的温度控制报警程序-STC5410-based single-chip temperature control of the police procedures

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

avr单片机，对目标板的编程，测试显示灯，发送串口返回值-avr microcontroller, the target board programming, testing lights, sending serial return values

codewarrior for hcs12 摩托罗拉16位单片机编译工具codewarrior的30天代码无限制试用版注册文件-Motorola MCU 16 compiler tools codewarrior 30 days of unlimited trial version code registration documents

用RVMDK生成bin格式的可执行文件．-Bin format RVMDK generated by the executable file.

keil c51编写的TLC549驱动函数，经过了测试的-keil c51 ?嘈

KeilC51manual

完全读写EEPROM24系列的单片机程序-fully read and write EEPROM24 series of SCM procedures