AVR开发板范例程序,WS开发板配套_51_汇编源程序

红外通信是利用950nm近红外波段的红外线作为传递信息的媒体，即通信信道。发送端采用脉时调制（PPM）方式，将二进制数字信号调制成某一频率的脉冲序列，并驱动红外发射管以光脉冲的形式发送出去；接收端将接收到的光脉转换成电信号，再经过放大、滤波等处理后送给解调电路进行解调，还原为二进制数字信号后输出。-Infrared communication is the use of near infrared 950nm infra-red as the transmission of information media, namely communication channel. The sending end when the use of pulse modulation (PPM) approach will be a binary digital signal into a frequency modulation of the pulse sequence, and driver fired infrared tube to the form of light pulses sent receiver will receive the pulse of light conversion to electrical signals , and then, after amplification, filtering and other treatment to the demodulation circuit after demodulation, reduced to a binary digital signal after the output.

Cortex-M3权威指南Cn.rar Cortex-M3权威指南Cn.rar-Cortex-M3 authoritative guide Cn.rarCortex-M3 authoritative guide Cn.rar

本文件提供了关于ATMEGA16A的SPI的硬件结构及其使用代码，同时，本文件也适用与ATMEGA16及ATMEGA16L-This document provides information on the SPI hardware ATMEGA16A structure and the use of code, at the same time, this document also applies with ATMEGA16 and ATMEGA16L

Atmega169 usart 驱动-Atmega169usart drive

一个电子仪器的开发原程序！绝对可以用！一个电子仪器的开发原程序！绝对可以用！-The development of an electronic instrument the original program! Absolutely can! The development of an electronic instrument the original program! Absolutely can!

红外遥控信号自学习和还原的资料，值得研究学习。-Infrared remote control signals to restore the self-learning and information, is worth studying to learn.

周立功 smartArm2200 的基于uCOS-II的综合实验源程序，绝对物有所值-Week smartArm2200 Ligong uCOS-II based on a comprehensive experimental source, the absolute value for money

两篇很好的论文，论文中就已经包括(c51编写）源码。很不容易从内网上获得。-Two very good papers, papers have been included (c51 prepared) source. Easy online access from the inside.

aduc842的c程序例子-ADUC842 procedures example of c

闪光灯测试仪的程序代码，有基于proteus的仿真-Flash tester code, there are simulation-based proteus