AVR library for IR communication.

键盘扫描LED驱动芯片ch451资料及c语言源代码-keyboard scan LED driver chip ch451 information and c language source code

傅杨烈的单片机教程，是我所见过的最详尽的单片机及嵌入式系统教程。-Lie Yang Fu SCM Guide, I have seen the most comprehensive SCM and Embedded Systems Directory.

PIC的资源,用PIC16F505做段码显示的C语言样例-Single and multiple 7-segment displays, multiplexing, and BCD counting on baseline PICs (using the PIC16F505)

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

Sensiron SHT10 (Temperature and Humidity Sensor) by TI MSP430F2350

步进电机单片机驱动程序-stepping motor driver program

自动打铃器 运用单片机的编写的，不仅含有图形还有编程-Automatic bell device prepared by use of single chip not only contains the graphics there are programming

MSP430 的AD转换，经过MSP430F247测试完全可用 -MSP430 the AD conversion, after the test completely available MSP430F247

收音模块TEA5767模块驱动程序及测试程序。-the driver of tea5767 module.