LPC2103，ADC源码，很好用的，IAR环境下编译

12864液晶中文字库。以及一些液晶的控制方法-12864 LCD English font

胡家荣（hjr7581@163.com）用KEIL写的的几个LCD、串口等方面的程序-Hu Jia-rong (hjr7581@163.com) with KEIL wrote several LCD, Serial procedures etc.

这是一个128×64 的液晶显示屏的驱动程序-This is a 128 × 64 LCD driver

6位数码管显示动态显示：HELLO.并有向左移动显示的动作效果-6 digital tube display dynamic display: HELLO. And moves to the left shows the effect of mobile

一个简单实用的单片机键盘扫描程序。键盘为4*4扫描的键盘，通过行列扫描进行键码判断，并通过串行口或者485信号输出键码。应用于银行系统。-A simple and practical single-chip microcomputer keyboard scanner. 4* 4 keyboard for keyboard scanning, scan through the ranks to determine the key code and, through the serial port or a key code signal output 485. Applies to the banking system.

一般机箱的51单片机温控程序设计，程序较长，在关键部分做了注释。-51 single-chip general chassis temperature control program design, procedures longer to do the key part of the Notes.

电话拨号程序，开发环境：vc6.0,在win2k下调试通过。-Telephone dial-up procedures, development environment: vc6.0, in win2k adopted under the debugger.

一个液晶显示器TX240128程序。我把我小孩的相片做在上面了，如果你用51的片子就能调试你的显示器了。端口连接在程序中有定义。你看下就知道了哈！-A liquid crystal display TX240128 procedures. I put my kids to do in the photo above, if you use the 51 films will be able to debug your display has. Port in the procedure definition. You know facie Ha!

本程序是用GCC编写的超声波传感器智能小车波避障程序，单片机是AVR16-The program of the intelligent car obstacle avoidance by ultrasonic sensor

利用单片机实现的控制电梯系统，参考2004年湖北省大学生电子设计竞赛原题设计。-Realize the use of single-chip control of elevator systems, a reference in 2004 in Hubei Province Undergraduate Electronic Design Contest Design the original title.