基于STM32F103的各种驱动配置

自己用编写的雷达线性调频信号产生器，信号幅度为-1~1，其中另外的一些参数可以根据需要改动(themselves with the preparation of the linear FM radar signal generator, the signal amplitude ~ 1-1, which some other parameters can be changed as needed)

此程序主要是为了完成图形的上下左右的移动、缩小和放大。(This procedure is to complete the graphics up and down around Mobile, narrow and amplification.)

三相无刷电机反电动势控制程序，瑞萨原厂出品(Three-phase brushless motor back EMF control procedures, Renesas factory produced)

说明：  CCS平台PE4302驱动,亲测可用，附带使用程序(CCS Platform PE4302 Drivera,TM4C123GX)

用单片机控制输出电压，MCU控制输出，我没有用过，大家可以参考(MCU control the output voltage, MCU control output, I have not used, we can refer to)

AutoPostWithCookies

说明：  一个基于QT平台的倒计时小程序，插入到项目里比较好用(A countdown program based on the QT platform, which is easy to insert into the project)

Bank Management System

在实际应用中，原始的BP算法很难胜任，因此出现了很多的改进算法。BP算法的改进主要有两种途径，一种是采用启发式学习方法，另一种则是采用更有效的优化算法。本例采用动量BP算法，来实现对网络的训练过程，动量法降低了网络对于误差曲面局部细节的敏感性，有效地抑制网络陷于局部极小。 (In practical applications, the original BP algorithm very difficult to do, so there were a lot of the improved algorithm. BP Algorithm There are two main channels, a heuristic learning method is adopted, another is the introduction of more efficient optimization algorithm. In this case the use of momentum BP algorithm to realize the network training process, momentum method to reduce the network error surface for the local details of the sensitivity of the network effectively inhibited in a local minimum.)

这是一个实现找出欧拉路径的的算法，比较完美的解决了欧拉算法(This is an implementation of the algorithm to find Euler path, the more perfect solution to the Euler algorithm)