philips单片机IAP操作的测试代码，可以根据自己需要进行修改，为C语言接口...

这是一个步进电机调速的程序，可以完成100级的调速。-This is a stepper motor speed control procedures, to be completed 100 of the governor.

直流电机调速实验C语言程序,使用L298N驱动-DC Motor Speed Experiment C language program, use the L298N drivers

MSP430有许多寄存器来设定程序的频率和周期，本文总结如定时器A,看门狗，模拟比较器等的代码，供大家参考学习.-MSP430 has a number of registers to set the procedures for the frequency and cycle, such as This paper summarizes the timer A, watchdog, analog comparator, such as the code for your learning.

KEIL 51上的数字电压表实验程序 用C编写 已经调试过-KEIL 51 on the digital voltage meter experimental procedures have been prepared with C debugging off

Proteus的数码管仿真电路，希望对大家有点用，入门级的。-Proteus simulation of the digital control circuit, in the hope that we are a bit used, entry-level.

本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.

LCD1601驱动程序包，源码 程序-LCD1601 driver package, source code program

20键PS2小键盘中断服务程序-20 keys PS2 small keyboard interrupt service program

这是一套用C语言完成的128*64液晶屏驱动，没有设备，未验证可用性-This is a set of C language with the completion of the 128* 64 LCD screen-driven, not equipment, not to verify the availability of

这是sitronix（台湾省公司）lcd驱动ic被应用在51低速单片机上的代码。-This is sitronix (Taiwan Province of the company) lcd driver ic used in 51 low-speed single-chip code.