PIC

此程序可以实现两个单片机之间的相互通信；串口采用方式1工作，10位异步接受和发送，波特率可变，由定时器1控制；且含有校验-This program can be achieved between the two microcontrollers communicate with each other serial port mode 1 using the work of 10-bit asynchronous receive and send, variable baud rate, from Timer 1 control and contains a checksum

关于CY68013开发USB2.0批量上传的实例.想从事USB开发的可以参考.-CY68013 development on the bulk upload examples of USB2.0. Would like to engage in USB development can refer to.

硬件协议栈芯片W3100A和51单片机实现tcp客户端程序，在keil51环境中-hardware protocol stack and 51 W3100A chip MCU tcp client, in keil51 environment

两相四线步进电机驱动,控制程序.C语言编写-Two-phase four-wire stepper motor driver and control program. C language

Sunplus SCM voice broadcast, modify the playback documents, will be able to broadcast their own voice.

ARM程序，基于无线模块nrf905，可实现无线发送与接收，在LPC2103上测试通过-ARM program, based on the wireless module nrf905, can realize the wireless sending and receiving, in the LPC2103 on test

是对sd卡驱动的分析以及读写分析寄存器配置-Is the sd card-driven analysis and analysis of reading and writing configuration registers

采用51系列单片机 用TI公司的TLC549采样，MAX7219控制数码管四位显示，以测试通过-51 Series MCU with TI

[文件名] Touch.c [功 能] 8051单片机驱动ADS7846/ADS7843芯片 [简 介] ADS7846/7843芯片 适合用在4线制触摸屏，它通过标准SPI协议和CPU通信，操作简单，精度高，当触摸屏被按下时（即有触摸事件发生）则ADS7846向CPU发中断请求，CPU接到请求后，应延时一下再响应其请求，目的是为了消除抖动使得采样更准确。如果一次采样不准确，可以尝试多次采样取最后一次结果为准，目的也是为了消除抖动。-Driver source code of touch-sensitive screen with ADS7846/7843

版本：1.0 Target：89S51 程序描述：这个程序利用89X51连接绘图型LCD，然后显示出：-Version : 1.0 Target : devised procedures Description : The program uses 89 X51 graphics link-LCD, then showed :