max232 communications driver source

用从c++编写的串口通信程序，内有详细的了解并设置串口参数的源码，并含通信原理-prepared from the use of serial communication program, with detailed understanding of serial port parameters and set up the source code, and communication with Principle

是关于山特电源通信规约的串口通信程序，功能是把电源监控器的采集数据上送到规约前置机中。-GOLD comunication rule

232通讯 用于电脑232通讯 可以发送和接受数据-232通讯

通过rs232，发送一条消息到另一端，可以打开端口，检查打开后才输入消息。

dos 下的串口编程源代码，可使用中断-dos under the serial programming source code can be used interruption

这是一个LINUX下多串口驱动程序，是一个非常成熟的代码，已经卖出很多了，非常难得，希望能给大家带来帮助。里面包括了协议及控制，校验等等代码，希望大家支持-This is a multi-serial port under LINUX driver, is a very sophisticated code, have sold a lot, very rare, I hope everyone can help. Which include the protocol and control, validation code, etc. I hope you will support

Verilog实现的UART程序，用ISE打开工程文件即可-Verilog implementation UART program, open the project file with the ISE can be

vb串口通讯vb串口通 vb串口通-vb serial communication serial port vb serial vb Qualcomm Qualcomm

串行口是计算机一种常用的接口，具有连接线少，通讯简单，得到广泛的使用。常用的串口是RS-232-C接口(又称EIA RS-232-C)它是在1970年由美国电子工业协会(EIA)联合贝尔系统、调制解调器厂家及计算机终端生产厂家共同制定的用于串行通讯的标准。它的全名是"数据终端设备(DTE)和数据通讯设备(DCE)之间串行二进制数据交换接口技术标准"该标准规定采用一个25个脚的DB25连接器，对连接器的每个引脚的信号内容加以规定，还对各种信号的电平加以规定。传输距离在码元畸变小于4%的情况下，传输电缆长度应为50英尺。 　　Linux操作系统从一开始就对串行口提供了很好的支持，本文就Linux下的串行口通讯编程进行简单的介绍.-computer serial port is a common interface, with connecting lines, simple communications, to be widely used. It is commonly used serial RS-232-C interface (also known as the EIA RS-232-C) it is in 1970 by the American Electronics Industry Association (EIA) Joint Bell System, a modem manufacturers and computer terminal manufacturers developed for serial communication standards. Its full title is "data terminal equipment (DTE) and data communications equipment (DCE) between serial binary data exchange interface technology standards," the use of a standard 25 feet to the DB25 connector, the connector pin of each signal content requirements, but also the right signal--

pascal写的一个通讯例子 -The communication example writed by pascal