from 16* 16 lattice Store applications, c source

ZLG SmartARM2300的出厂演示程序，包含板子上的所有驱动程序，基于ADS+uCos-ZLG SmartARM2300 of the factory demo program, including the board of all drivers, based on ADS+ UCos

ARM7 S3C44B0X 音频实验代码-ARM7 S3C44B0X Experimental Audio code

三星公司的S3C44B0X开发板的配套光盘的PWM实验源程序-Samsung"s S3C44B0X development boards supporting experimental discs PWM source

深圳优龙科技LPC2468开发板BIOS.-Shenzhen excellent technology Liuzhou LPC2468 development board BIOS.

基于linux操作系统ATMELARM9200 开发平台的7289控制器驱动程序-ATMELARM9200 operating system based on Linux Development Platform 7289 controller Flooding action procedures

S08例程：本程序是显示模块的例程，所接器件为四位八段led数码管，其中PTB0-PTB3 与数码管的位选相连接，PTB4，PTB5与74LS164连接-S08 routines: this process is the routine display module, the access device for four eight led digital tube, which PTB0-PTB3 bit digital tube and connected to the election, PTB4, PTB5 connect with 74LS164

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

Jtag for arm microcontroller.

lpc2131 IAP在线升级演示程序，升级方式为UART。-lpc2131 IAP-line demonstration program to upgrade, upgrade to UART.

介绍了微控制器I2C软件包接口说明，和软件包源程序。-Introduction of the I2C interface package that the source code and software packages.