脉宽调制占空比变化的程序，已经调试过，可以直接使用…

lcd 与C51 的驱动程序 1、本实验箱采用的液晶显示屏内置控制器为SED1520，点阵为122x32，由两片SED1520组成，由E1、E2分别选通，控制显示屏的左右两半屏。-LCD C51 and a driver, the use of experimental boxes LCD screen embedded controller for SED1520, to 122x32 dot matrix, composed of two SED1520, E1, E2 respectively strobe control screens around two semi-screen.

430成都技术培训会代码，使用IAR-4.10打开。-430 technical training in Chengdu will be the code, the use of IAR-4.10 open.

本应用笔记描述了一种完全可行且高度灵活的软件应用，使用dsPIC30F 来控制无传感器无刷直流（brushless DC，BLDC）电机。 此软件将dsPIC30F 外设广泛应用于电机控制。所实现的无传感器控制算法特别适用于风扇和泵。-The application notes described a completely feasible and highly flexible software applications to control the use of dsPIC30F Sensorless Brushless DC (brushless DC, BLDC) motor. This software will be widely used in dsPIC30F motor control peripherals. The realization of sensorless control algorithm is particularly applicable to the fan and pump.

LM3033的显示控制程序 LM3033自带字库 用途比较广 但控制简单明了 -LM3033 display control program LM3033 uses its own font broad but simple and clear control

opentcp-8052-1-0-4-1-src,包含了常用的网络协议，已经成功的移植到51中-opentcp- 8052-1-0-4- 1-src, contains commonly used network protocol, already successful transplant 51

VHDL编写的八位9值信号的中值输出方法，特点是不采用流水或状态机设计，因此速度较快-VHDL prepared by eight of the nine value signal output value method, which is characterized by not using water or state machine design, therefore faster

一个用C51驱动PT6324+VFD的源程序，绝对可执行

一个非常好的单片机读写液晶的程序，已经服了源码。-A very good single-chip LCD to read and write procedures, had already served a source.

很好的c语言24c01代码，经试验可以使用，分享一下-24c01 good c language code, as the pilot can use, share

DES算法的ST7单片机实现程序-DES algorithm ST7 MCU procedure