easyarm1138 c lcd12864 chuanxing

一个用单片机控制饲服电机的程序，采用ＯＭＲＯＮ光纤感应器实现的剪纸机，已通过调试-By feeding a single-chip microcomputer to control the electrical service procedures, the use of fiber-optic sensor OMRON realize the paper-cutting machines, has passed through debugging

测试GPIF用的原理图、上位机程序，以及固件-GPIF test used schematics, PC procedures, as well as firmware

单片机实现数据采集并传送到上位机-MCU data acquisition and transmission to the PC

51 单片机的经常用到的子函数，非常具有参考价值。-51 SCM Functions frequently used, very useful.

通讯规则: 1:时钟7.3728 MHz/波特率9600/9个数据位/奇校验/1个停止位/硬件多机通讯功能/ 2:通讯连接采用硬件MAX485,双向单工 3:每个上行/下行的数据包的字节个数都是一样的(通讯数据量) 4:每个上行/下行的数据包都采用CRC8校验 5:数据接收采用中断+查询的方式 6:总是由主机向从机发送一个数据包,从机收到数据包后向主机回复一个数据包 7:不管是主机还是从机,如果收到的数据包有任何错误,都将丢弃该数据包,等效于没有接收 8:从机之间不能相互通讯,必须通过主机才能交换数据 9:无效地址是0,主机地址是1,从机地址是2.3.4......广播地址是255 -err

FSTN LCD driver:ST7565P,显示驱动程序源代码.-FSTN LCD driver: ST7565P, display driver source code.

MT8888芯片的C51读写程序-MT8888 chip C51 literacy procedures

电机测速源码程序，好使的已经通过测试了。非常精确-Motor Speed-source program, so that has passed the test. Very precise

语音芯片PM50八方源代码，在播音函数中写入你需要播音的例子即可播放对应的语音。-voice chip PM50 from all source code, the audio function you need to write radio broadcast of examples corresponding voice.

8051上的CRC8校验 A CCITT-8 CRC calculator. The source contains both the calculated (smaller but slower) version, and the table driven (faster but larger) version.-8051 CRC8 check on the CCITT A-8 CRC calculator. Th e source contains both the calculated (smaller but slower) version, and the table driven (faster but larger) versio n.