uCOS周立功SmartARM2200周

周立功 smartArm2200 的基于uCOS-II的综合实验源程序，绝对物有所值-Week smartArm2200 Ligong uCOS-II based on a comprehensive experimental source, the absolute value for money

mega64 +　VS1003 + SD卡，液晶使用的 Nokia5110液晶（方便，可以直接贴在板子上）,，采用手机锂电池供电 配外壳 -mega64+ VS1003+ SD card, LCD used Nokia5110 LCD (convenient, can be directly attached to the board on), the use of lithium battery-powered mobile phones with shell

很有参考价值的51单片机串口程序，正在搞串口的看一看-great reference value of 51 MCU procedures, is now pursuing a look at the serial port

本要求适用于Microcon-T02半导体冰箱控制板（以下简称控制板）。本控制板由电源板、显示控制板两部分组成。-The requirements apply to Microcon-T02 semiconductor refrigerator control panel (hereinafter referred to as the control panel). The control panel from the power supply board, display panel is composed of two parts.

飞思卡尔的编程资料，开发软件的调试，以及智能车路线识别系统文章。 -Freescale" s programming information, development of software debugging, and intelligent vehicle identification system routes the article.

步进电机的单片机控制，可以在Proteus下进行仿真-Stepper motor microcontroller control, can be carried out under the Proteus simulation

周立功的关于LPC214X硬件触发转换程序.

单片机最小系统，两位LED数码管由串口输出接两个164驱动，Lout,Rout为左右声道输出，SET， ALT0， ALT1为三个按键，也可自己在开始的I/O定义改成你想用的I/O口；12M晶振，若用89C51则只可装下约14首歌曲，用89C52则可装下近40曲-The smallest single-chip system, the two LED digital tube by the serial output driver 164 then two, Lout, Rout output for the left and right channels, SET, ALT0, ALT1 three buttons can also be their own at the beginning of the I/O definition change you want to use the I/O port 12M crystal, if one uses a 89C51 only loaded about 14 songs can be loaded with 89C52 under near 40

MSP430下的一个微内核操作系统，很实用。做到底层无关，稍加修改可以移植到其他平台下。-MSP430 under a micro-kernel operating system, is very practical. Do not bottom, a little change can be transferred to other platforms.

S3C44B0扩展16C554串口，包括原理图和源码 原来上传过源码，看到很多人下载，考虑到下载者阅读方便，所以这次增加了原理图。-16C554 serial S3C44B0 expansion, including schematics and source code uploaded the original source, to see a lot of people to download, taking into account that those who download the ease of reading, so the increase in schematics.