用C语言编写的交通灯上的程序，这里只取出了读取8563的一段程序。...

绕线机计数功能，可调节。用光电开关和AD-AD

这个是我写的以t6963为主控芯片的显示屏的程序，能控制所有以t6963为主控的屏-this is what I wrote to the t6963 to the display control chip procedures to control all of the controlling t6963 screen

Visual Basic 6.0企业版，AT89C52型单片机下调试通过。-Visual Basic 6.0 Enterprise Edition, AT89C52-type single-chip debugging through.

avr单片机atmega16，用键盘控制，可显示多种不同的跑马灯程序-avr microcontroller atmega16, keyboard control, can display a wide variety of marquees program

8051f02x系列单片机的定时器的应用例程-8051f02x Series MCU application timer routines

51写的一个例子, 驱动IC为T6963.

单片机是52的，P0口连到四个数码管的七个管脚，其中两个冒号点为最后两个数码管的DOP点，P1.0至P1.3为四个数码管的选通端，低电平有效。程序2较完整，可实现设定时间功能。-Singlechip is 52, P0 port connected to four of the seven-pin digital tube, two of which point to the last two colon tube DOP-point digital, P1.0 to P1.3 for the election of four digital tube pass-side, active-low. 2 a more complete procedure, set the time function can be realized.

简易电子钟的设计 源程序-simple electronic clock design source

这是由C51单片机实现的接触式IC卡的读写-This is achieved by the C51 single-chip contactless IC card read-write

PIC的资源,用PIC16F505做段码显示的C语言样例-Single and multiple 7-segment displays, multiplexing, and BCD counting on baseline PICs (using the PIC16F505)