AT91RM9200控制AMBE200声码话的程序

用C8051F实现LED显示的C程序。源码-LED display with C8051F achieve C program. Source

这是用于显示波斯语及阿拉伯语及英语中的手臂，源代码与ili9325 液晶。

lpc2131 IAP在线升级演示程序，升级方式为UART。-lpc2131 IAP-line demonstration program to upgrade, upgrade to UART.

using keil to subtract 2 "string number" (MCB2378 ARM)

用FPGA做的RAM，源码，调试通过，有工程-FPGA to do with RAM, source code, debugging through, there are works

lgui类似minigui的gui，国产，可用于嵌入式系统，-lgui similar MiniGUI the gui, homemade, can be used for embedded systems,

powarm s3c2440 main board schematics

EasyARM2131开发板源码之一----------- 3．GPIO输出实验－流水灯实验-EasyARM2131 one source development board----------- 3. GPIO output experiment- water Lights

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (