著名的uCOS II 在ARM7 上的移植

天嵌的4.3寸屏上移植uCOSII，含uCGUI，希望对大家有用(UCOSII day embedded 4.3 inch screen transplantation, including uCGUI, hope useful for everyone)

STM32F103驱动蜂鸣器的例子，是学习STM32的好资料。(STM32F103 drive the buzzer example, STM32 learning good information.)

基于uCOS操作系统和LPC2292硬件平台的嵌入式系统程序，包括GPS代码功能实现-UCOS-based operating systems and hardware platforms LPC2292 embedded system procedures, including GPS functionality realize code

基于uCOS-III+STemWin+FatFS+ARM_DSP_Lib的示波器源码。(Oscilloscope source code based on uCOS-III+STemWin+FatFS+ARM_DSP_Lib.)

dm9000a，DM9161AE的驱动程序，写的很详细。可以用在ucos上(dm9000a, DM9161AE driver, written in great detail. Can be used in ucos on)

嵌入式系统ucos II 2.9版源代码(embed system os ucos II 2.9 source code)

LPC2114基于UCOSII的SPI驱动使用的例子。通过硬件SPI接口控制LED数码管显示数,中间件代码(LPC2114 SPI UCOSII the drive using examples. Hardware SPI interface to control the number of LED digital tube display, middleware code)

综合实验源代码－计算器-comprehensive experiment source code-Calculator

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

KEIL 下的UCOSII移植，里面有LED的点灯，点灯是需要按一下按LED灯亮一下，还有串口，不过波特率不准，只实现接收进入中断，其实就是完成了中断进入、信号量创建，对初学者十分有用。此例子用的是KEIL公司的MCB2300开发板，和英蓓特的LPC2300一样，原理图可以在KEIL公司官网上下到。-KEIL under UCOSII transplantation, there are LED