本人移植 uboot后代码注释 注释很详细的

基于LPC2368的LCD控制程序，同时有Jlink下的调试配置-LPC2368 based on the LCD control procedures, at the same time has under the debug configuration Jlink

运算放大器基础，为PDG格式，是最让人头疼的格式，不过还是可以一看-Operational Amplifiers basis for PDG format, is the most worrisome format, but one can still see

at91arm7处理器的启动源码-The prcocessor s starting source code of the at91arm7.

针对传统电液比例控制系统的性能较差，本文提出了一种基于ARM和uC/OS-II的电液比例控制系统的设计，并详细介绍了以ARM内核微控制器LPC2292和电机驱动芯片LMD18200为核心的硬件电路，以及嵌入式操作系统μC/OS-II在ARM7上的实现。-Traditional electro-hydraulic proportional control system for poor performance, this paper presents an approach based on ARM and uC/OS-II of the electro-hydraulic proportional control system design and described in detail in order to ARM core LPC2292 microcontroller and motor driver chip LMD18200 at the core of the hardware circuit, as well as the embedded operating system μC/OS-II in the realization of ARM7.

S3C44B0X的BIOS程序，完成BOOTLOADER功能-S3C44B0X the BIOS program, the completion of BootLoader function

arm7easyarm测试程序，包括所有部分，在ads下使用。-arm7easyarm testing procedures, including all parts, the use of the ads.

msp430串口通信的源码，实现了串口1的通信，串口接收到数据后回发给PC端。串口初始化可以参考。

基于S3C44B0X的模型可以实验IDE，PWM，USB等LED。。。。对于初学者来说，嵌入式系统非常有用。

C51单片机与nrf2401使用，nrf2401调试程序。-C51 MCU and nRF2401 use, nrf2401 debugger.

H-JTAG配置文件 基于ST39VF1601 ST39VF3201 ST29VF6401的LPC2220 CPU 及基于ST391601的LPC2470 CPU 内附有H-JTAG 7.0的安装程序及源代码 H-JTAG的源理图(WIGGLER) NOR FLASH 烧写指南 H-JTAG 用户手册.pdf S3C4510 BootLoader的实现与分析 (附源代码).rar 及在CTEST.RAR中的一些实践文件-H-JTAG configuration file ST39VF1601 ST39VF3201 ST29VF6401 based on the LPC2220 CPU and based on the LPC2470 CPU containing ST391601 have H-JTAG 7.0 installation procedure and the source code of the source of H-JTAG rationale Figure (WIGGLER) NOR FLASH programmer H-JTAG Users Guide Manual. pdfS3C4510 BootLoader Implementation and Analysis (with source code). rar and CTEST.RAR document some of the practice