登录
首页 » 嵌入式系统 » 源码for the Linux终端重要程序

源码for the Linux终端重要程序

于 2022-02-09 发布 文件大小:601.66 kB
0 182
下载积分: 2 下载次数: 1

代码说明:

Minicom源码,用于Linux终端的重要程序

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Embedded Linux summarize, it can be said is a small experiences.
    嵌入式Linux总结,可以说是一个小的心得体会。-Embedded Linux summarize, it can be said is a small experiences.
    2023-04-27 16:45:03下载
    积分:1
  • modbus 源码
    Modbus 协议是应用于电子控制器上的一种通用语言。c语言写成,共五个文件,两个头文件,一个主函数,一个写,一个读。
    2022-05-30 11:59:52下载
    积分:1
  • Quartus II9.0 256色VGA显示
    资源描述Quartus II9.0 256色VGA显示。基于SF-EP1C开发板的verilog代码。
    2022-06-03 01:02:01下载
    积分:1
  • MFC串口编程实例(20个)
    MFC串口编程实例,总共20个实例,有基于MScom控件的编程,也有基于windowsAPI的串口编程,提供了完整了串口类,可直接使用,有完整的串口调试助手的源码,比较有学习价值。
    2022-04-27 17:25:15下载
    积分:1
  • 51
    51单片机源代码,LEd,串口实验的源代码,等等http://baike.baidu.com/link?url=CkkKkYMGs3luV0bbcqHO8ipPOoRek3REtqtWnF9k1aYqTNF863xUiKZYzcOP8wY_
    2022-03-25 21:54:21下载
    积分:1
  • L298N是ST公司生产的一种高电压、大电流电机驱动芯片。该芯片采用15脚封装。主要特点是:工作电压高,最高工作电压可达46V;输出电流大,瞬间峰值电流可达3A...
    L298N是ST公司生产的一种高电压、大电流电机驱动芯片。该芯片采用15脚封装。主要特点是:工作电压高,最高工作电压可达46V;输出电流大,瞬间峰值电流可达3A,持续工作电流为2A;额定功率25W。内含两个H桥的高电压大电流全桥式驱动器,可以用来驱动直流电动机和步进电动机、继电器线圈等感性负载;采用标准逻辑电平信号控制;具有两个使能控制端,在不受输入信号影响的情况下允许或禁止器件工作有一个逻辑电源输入端,使内部逻辑电路部分在低电压下工作;可以外接检测电阻,将变化量反馈给控制电路。使用L298N芯片驱动电机,该芯片可以驱动一台两相步进电机或四相步进电机,也可以驱动两台直流电机。-L298N is produced by ST a high-voltage, high current motor driver chip. The chip uses 15-pin package. Main features are: high voltage, the maximum working voltage up to 46V output current, instantaneous peak current up to 3A, continuous operating current of 2A rated power of 25W. Contains two H-bridge high-voltage high-current full-bridge driver can be used to drive DC motors and stepper motors, relay coils and other inductive load using standard logic level signal control has two enable control terminal, input signal without affecting the case to permit or prohibit the device work a logic supply input, so that part of the internal logic circuits at low voltage work can be an external sense res
    2022-02-05 00:53:15下载
    积分:1
  • This is linux kernel source code 58 C source, the source code is compiled by
    这是linux内核C源代码58的源程序,这个源代码已经编译通过-This is linux kernel source code 58 C source, the source code is compiled by
    2022-01-26 00:40:48下载
    积分:1
  • 成都理工大学基于MAXPLUS II 的设计过程报告内涵有源程序及设计过程中的调试:在文本编辑窗口中输二进制8位优先编码器的程序; 3设计驱动显示程序如下...
    成都理工大学基于MAXPLUS II 的设计过程报告内涵有源程序及设计过程中的调试:在文本编辑窗口中输入二进制8位优先编码器的程序; 3设计驱动显示程序如下: 5采用原理图方式设计如下: 6引角分配图如下: 7仿真结果如下: -Chengdu University of Technology II-based FPGA design process report connotation source and the design process Debugging : in the text editing window importation of eight priority binary coding of procedures; 3 shows the design-driven procedures are as follows : 5 diagram using design methods are as follows : 6 primers angle distribution plan are as follows : 7 simulation results are as follows :
    2022-12-10 21:50:03下载
    积分:1
  • 本程序功能是在FPGA上nios处理器的sram接口程序。
    本程序功能是在FPGA上nios处理器的sram接口程序。-The program features in the FPGA on the Nios processor
    2023-04-25 22:30:03下载
    积分:1
  • STM32F4_SPI_Ethernet
    示范 STM32F4DISCOVERY 板,STM32F4x7_ETH_LwIP_V1.0.0,https://bitbucket.org/blackbird745/stm32f4-webserver/src,我上传的项目是实际上 ST 发布独立 httpserver — — 将被发现在修改后的版本:
    2022-07-20 16:09:45下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载