CCS4.1.2 源代码

本程序是关于PIC定时中断服务程序，希望对大家有帮助。-TIME0

appnding a file at the end of tohtr

软件仿真SPI串行EEPROM时序控制的C程序，在DOS下使用BC31编译

这是在嵌入式开发系统上使用的LCD到VGA信号转换芯片的Datasheet-This is in the embedded development system used on LCD to VGA signal converter chip Datasheet

基于EasyArm2200和ucOS2的SD卡文件系统的实现，使用ADS编译器-EasyArm2200 and ucOS2 based on the SD Card File System Implementation, using ADS compiler

富士通单片机串口与CAN总线通信程序，单片机的类型为MB96F313，晶振选择类型需修改，嵌入式应用程序

通常的汉字显示方式是先根据所需要的汉字提取汉字点阵（如16×16点阵），将点阵文件存入ROM，形成新的汉字编码；而在使用时刚需要先根据新的汉字编码组成语句，再由MCU根据新编码提取相应的点阵进行汉字显示。在这种显示方式中，如果使用的流字数量较大或语句较多时，利用汉字的新编码组成语句将是一件十分繁琐而枯燥的工作。针对这种情况，本文提出了一种十分简单的方式――直接利用PC机的汉字内码作为单片机系统的编码。-Chinese characters are usually displayed in accordance with the need to first extract of the Chinese character dot-matrix (such as 16 × 16 dot matrix), will be deposited into the matrix documents ROM, a new Chinese character encoding while just need to use the Chinese characters according to the new code composed of statements, and then by the MCU according to the new code to extract the corresponding Chinese character dot-matrix display. In this show the way, if you use the word flow statement number of the larger or more, the use of Chinese characters composed of a new coding language will be a very tedious and boring work. In view of this situation, this paper presents a very simple way- direct access to PC-code character encoding as a single-chip microcomputer system.

实现2路电压采集，采用ADC0808实现，C51编程，有proteus仿真！有较详细的程序注释。采用共阴数码管实现。程序中的串口设置可用在调试时使用。

手机短信的protues仿真,带有串口及液晶显示,拿来分享,感兴趣的拿去研究研究.-SMS protues the simulation, with a serial port and the liquid crystal display, used to share research of interest to study away.

实现了AVR环境下的单总线器件18B20的操作，程序结构简单紧凑，实用性较强-Wife of mother