本软件程序为KEILc51开发环境，实现AT89S52单片机与PS2键盘的通讯，同时用液晶LM3037实现同步显示...

ucos的PPT课件 基本原理及其在9s12单片机上怎样移植-OUT PPT Courseware the basic principle and the 9s12 on how to transplant MCU

ST52单片机控制液晶显示的程序，含1602液晶的数据手册及字符手册，对初学者很有帮助。-Single-chip LCD ST52 control procedures, including data from 1602 LCD manual manuals and characters, very helpful for beginners.

单片机系统中的汉字显示 　　 摘要： 需要显示的汉字较多时，单片机系统中的汉字编码非常繁琐。本文介绍一种直接利用PC机的汉字内码作为单片机系统的汉字编码，以简化系统的设计。-SCM system of Chinese character display Abstract : The need to show the Chinese characters more, the SCM system of Chinese character coding very cumbersome. This paper presents a direct use of the PC as the Chinese character coding SCM Chinese character coding system to simplify system design.

很详细的LCD资料，找了好几才找到，对想了解LCD的朋友很有帮助的-Very detailed information on the LCD, to find to find several of our friends would like to know LCD helpful

SPI接口AD转换器代码 本代码实现了对串行（SPI）接口的软件模拟 这是在一个项目中要用到SPI接口的器件，调试成功，可以在WAVE下编译通过，可以直接调用 SPI接口AD转换器代码 2002/3/9 design by elven-SPI AD converter code of the source implementation of the serial (SPI) interface software simulation This is a project that will be used SPI interface devices, debug successful, the compiler through WAVE, and can directly call SPI AD converter code 2002/3/9 by design"s Eleven

蜂鸣器响 改变蜂鸣器的频率，通过改变延时时间 蜂鸣器的时间要是是靠延时来完成的-Buzzer buzzer ring to change the frequency by changing the delay time if the buzzer is the time to be completed by the time delay

这是LCD1602与msp430之间的通信,其实可以直接从51移植过来,但是一定要在硬件加上拉电阻,要不然是不通不过的,我说的是你用的是5V的LCD-This is the LCD1602 and communication between the MSP430 can in fact be a direct transplant from the 51, but must be coupled with pull-up resistor in the hardware, otherwise it is unreasonable, however, I say is that you use the LCD is 5V

只用cy7c68013实现的usbblaster!SDCC编译!-CY7C68013 achievable only usbblaster! SDCC compiler!

MSP430F413单相电表DEMO(编译器IAR 3.42A)-MSP430F413 single-phase meter DEMO (compiler IAR 3.42A)

十路无线智能器抢答器的程序源代码，功能基本都考虑到了，包括倒计时启动和暂停，终止，重启，倒计时设定-10 Lu wireless smart device Responder program source code, the basic functions are taken into account, including the countdown to start and be suspended, terminated, restart the countdown settings, and more