The use of Microchip

利用NRF905无线通信模块进行RS232通信-NRF905 use of wireless communication module RS232 communication

51通过CH375读写U盘的源码和原理图-51 CH375 literacy through the U-source and schematics

用C51实现的拼音输入法,这是改写的网友 embuffalo、独步上载在www.21ic.com自由发布区的由张凯原作的51上的拼音输入法程序。 原作使用了一个二维数组用以查表，我认为这样比较的浪费空间，而且每个字表的索引地址要手工输入，效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。 因为代码比较的大，共有6,000多汉字，这样就得要12,000 byte来存放GB内码，所以也是没办法的 :-( 编译结果约为3000h,因为大部分是索引表，代码优化几乎无效。 在Keil C里仿真芯片选用的是华邦的W77E58，它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限，没有上片试验，仿真而已。 打算将其移植到AVR上，但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样，现在还未搞定。还希望在这方面有经验的网友能给予指导。-C51 with the Pinyin input method, which is rewritten netizens embuffalo. Unrivaled www.21ic.com available in the free publication of the original work by Kai-51 on the Pinyin input method procedures . Appreciate the use of a two-dimensional array for the look-up table, I think this is a waste of space. Each of the characters but the index table to manually input address, efficiency is not high. I use the structure to rewrite a bit. We see now is this. Because the code comparison, a total of 6, more than 000 Chinese characters, this must

EZ430-rf2500无线网络源代码，配套实验源代码-EZ430-rf2500 WSN

支持I2C总线的EEPROM24lc256芯片的读写原程序-support I2C Bus EEPROM24lc256 chip reader original program

绘制LCD的RGB和喷墨打印机的 CMYK到CIELab的三维彩色视图 -LCD rendering of RGB and CMYK inkjet printers to the CIELAB color three-dimensional view

基于arm单片机LPC2134上液晶显示器1602驱动源程序开发-Arm based on the LPC2134 Single-chip LCD driver 1602 source code development

伽马辐射检测仪 -Gamma radiation detector

HCS08例程：本程序是PWM模块的例程，所用资源为单片机内部TPM模块，所接器件为LED-HCS08 routines: This procedure is routine PWM module, the resources used for the single-chip internal TPM module, the access device for the LED

实现对模数转化芯片TLC8032的控制逻辑，接收转化出来的数字信号，以便进行后续的数字信号传输-modulus to achieve right into the TLC8032 chip control logic, into the receiving digital signals for the follow-up to digital signal transmission