C51 TIMER 0的使用 Timer_0_mode_1_timer_gate_hard

usbcan的人机交互编程vc例程，嵌入式可以参考。-usbcan HCI vc programming routines, embedded can refer to.

串行通信程序，发送不是用中断方式，接收用中断方式，适用于程序的调试，液晶显示用的是1602-Serial communication program, sending instead of interrupt mode, receive mode using interrupted for Debugging, liquid crystal display using 1602

单片机控制80*16LED屏！！现在只能左移屏！-SCM 80* 16LED screen! ! Now only the left screen!

本文介绍了ISP程序设计方法，以及在SST和STC单片机上的具体实现方法-This paper introduces the ISP programming method, as well as in the SST and the STC on the concrete realization of single-chip approach

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

ATMEGA128单片机DATASHEET-ATMEGA128 MCU DATASHEET

单片机汉明码解码程序，8-4编码，接收从串口发送过来得数据-Hamming code decoding process Singlechip ,8-4 encoding, receiving from the serial data sent

麦迪工作室51开发板上跑马灯的试验代码。-Madison Studio 51 on the board to develop the test code Marquee.

三种单片机的区别,文中详细介绍了三种单片机的区别和使用范围-The distinction between three types of MCU, the text describes in detail the distinction between three types of MCU and the use of

pc机与rs232串口的通讯C51源程序。-pc computer and RS232 serial communications C51 source.