PIC单片机程序设计基础 入门教程.

93CXX的驱动程序-93CXX driver

PIC单片机从SPI，接收其他主SPI的数据-PIC Singlechip from the SPI, main SPI receive data from other

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

atmega16单片机与PC机串口通信,编程环境ICCAVR-communicate by single-chip atmega16 and PC through USART

介绍了DS1991信息按钮在文章中的应用，对编译中使用的读写程序作了说明。

这是一篇英文文献，由无线传感器网络的PEGASIS协议的原作者所写，希望能够给你提供帮助！-This is an English literature, from wireless sensor networks PEGASIS written agreement of the original author, I hope you can help!

一个高速单片机的超声波测距的例子，本例程使用的广茂达能力风暴机器人的超声测距卡。-a high-speed microcontroller Ultrasonic Ranging example, the routine use of the ability to Guangmao turmoil robot Ultrasonic Ranging cards.

c8051f020 i2c 源码。对其操作有详细描述。-dvsah dfvdnjkg b fdv

针对于msp430学习用的流水灯演示程序 完全正确-MSP430 for learning in the water with lights demo program completely correct

用于51单片机的定时器延时子程序，对定时有要求的进!-For 51 single-chip timer delay subroutine, from time to time has requested to enter!