Signaling lectures on the 7th. Doc and MG003003 SCCP signaling principle ISSUE1....

个人认为比较使用的几个VHDL源码之五decoder的源码-personally think that the use of the relatively few 5 VHDL source decoder source code

通信信号波达方向估计的MATAB程序，采用MUSIC和ESPRIT算法-communication signal DOA estimated Matlab procedures, and using ESPRIT algorithm MUSIC

啁啾光纤光栅的透射谱，反射普的特性仿真，主要用于光纤通信系统-Chirped fiber grating transmission spectra, reflecting the characteristics of Pu simulation, mainly used for optical fiber communication systems

光纤和光缆通信基本知识，也是华为的.rar-fiber and optical cable communication basic knowledge, but also Huawei. Rar

北京邮电大学的初级通信导0论PPT，对于初学者有帮助。-Beijing University of Posts and Telecommunications in the initial communication 0 Introduction On PPT, help for beginners.

KEIL C键盘扫描, KEIL C键盘扫描-KEIL C keyboard scanning, KEIL C keyboard scanning

BPSK调制程序，用于ＣＤＭＡ通信系统的信号调制．matlab写的！-BPSK modulation procedures for CDMA signal modulation system. Matlab write!

三点式振荡器是指LC回路的三个端点与晶体管的三个电极分别连接而成的电路，如图4-1（a）所示。图中三个电抗元件X1、X2、X3构成了决定振荡频率的并联谐振回路，同时也构成了正反馈所需的反馈网络。从相位条件看，要构成振荡器，必须满足： (1)极相连的两个电抗X1、X2性质相同。 (2)X1与X2、X3的电抗性质相反。-three-point refers to LC oscillator circuit with three transistors endpoint of three electrodes were connected with the circuit, Figure 4-1 (a) below. Figure 3 reactor components X1, X2, X3 decision constitutes a frequency of the oscillation parallel resonant circuit, but also constitutes a positive feedback for the feedback network. From Phase conditions, to constitute an oscillator, to be met : (a) very connected to the two reactor X1, X2 the same nature. (2) X1 and X2, X3 nature of the resistance-- contrary.

抄表机的抄表程序源码，平台是兰德抄表器，使用于电力行业的抄表度数管理。-Meter reading meter reading process source machine, the platform is the meter reading Rand, and the use of the meter reading in the power industry management degrees.

一个交换作业的源程序-a source of exchange operations