CC2500通信例子源代码，有兴趣的可以研究一下

用于控制带有Pololu电压反馈的线性执行器的线性位置和带有Tiensy 3.1 Pololu正交编码器的直流电机的角度位置的代码。

ARM4510B下的HDLC程序原码-ARM4510B HDLC procedures under the original code

串行flash芯片应用程序 25vf020-Serial flash chip applications 25vf020

一个uCOS-II下的tcpip协议栈实现，可用于嵌入式系统的网络应用开发-a uCOS-II under the TCPIP stack, which could be used in embedded system development of network applications

frequency allocation program which can be usefull for the telecommunication engineers

sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. SD目录 : SD卡读写模块的全部文件,一般不用修改. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改,而sdconfig.h通常会有改动. -sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. SD directory: SD card reader module all the documents, the general need not be amended. sdconfig.h document recommends not to put in SD directory, because the SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

44B0中文数据手册:嵌入式开发的参考资料-44B0 Chinese data Manual : Embedded Development reference

基于S3C2440，K9F1G08U0A NAND Flash器件，实现向NAND Flash的某个块写数据，然后从这个块读出数据。-Based on S3C2440, K9F1G08U0A NAND Flash devices, to achieve a block to the NAND Flash write data, and then read data from this block.

计算机体系结构中,关于DLXS的模拟程序.在vc6.0下编译通过.-Computer Architecture, on the DLXS the simulation program. Under the vc6.0 compile.

三星ARM9 芯片s3c2440开发linux时的引导程序源代码，相当于pc机的bios-Samsung ARM9 chip s3c2440 development of the Linux boot source code, which is equivalent to the pc-bios