nios环境下数码管驱动芯片max7219驱动程序，封装了八位数码管同时显示任意数值和单个数码管显示数值程序...

320240液晶中文字库，如果没有内置字库，应该有一定的参考价值-LCD 320,240 Chinese font, if there is no built-in font, there should be some reference value

dds 信号发生器的参考程序，，精工参考-dds reference signal generator procedures, Seiko reference

CH341USB转串口PCB原理图。 CH341USB转串口PCB原理图。-CH341USB schematic PCB serial transfer. CH341USB schematic PCB serial transfer.

UCOS在CS8900上面移植代码，已测试-UCOS transplant above code, have tested

用C8051F060开发的光功率计 由C51编写的程序-Optical Power Meter with C8051F060 development program prepared by the C51

STC单片机eeprom测试c语言程序（带串口发送程序）-STC Single-chip EEPROM test c language program (with Serial Send procedure)

gsm短消息报警程序，与硬件配合，完成开关量输入，短消息通知主人，用于防盗报警系统。-Short Message gsm alarm procedures, and hardware with complete switch input, short message to inform the owner for the anti-theft alarm system.

介绍了使用CS5520进行mV信号采集的源程序-Introduced mV signal acquisition using the CS5520 to the source

HCS08的AD例程：本程序是ADC模块的例程，所用资源为单片机内部ADC转换模块， 所接器件为电位器.-HCS08 s AD routine: This is the ADC module of the routine procedure, the use of resources within the ADC conversion for the microcontroller module, the device is connected potentiometer.

提供三片CS5463、一片CS5460A 电压数据采集和标定、温度和直流量的AD接口 -To provide three CS5463, a CS5460A-voltage data acquisition and calibration, temperature, and direct flow of AD Interface