该文件里包含了大量的常用经典的程序代码,可以为51编程者带来事半功倍的效果,...

12864中文说明，我认为很有用，希望关照-12864 Chinese note, I think very useful, I hope take care! ! ! !

离散 PID 控制 设计方法 ATMEL参考设计-PID control design method of discrete reference design ATMEL

一个用单片机开发的硬盘控制器,可以实现对大容量硬盘数据的读写!-With the development of a single-chip hard disk controller, can realize the large capacity hard disk data read and write!

欠过压报警电路的设计报告,ICL7100,模拟电路.-Toru 欠压agent changchu forlorn wind chirpy few forlorn rear cavity, ICL7100, Chang Yao-carrying wind.

c8051fxxx单片机所有外设C例程，希望对大家有用。-c8051fxxx Microcontroller C routines for all peripherals and hope for all of us.

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

虚拟声卡的详细说明！有一个虚拟声卡示波器，现在大量使用，并链接到地图与您分享！

红外遥控器7461的接收程序 其中有显示和键盘驱动-7461 infrared remote control receiver procedures which display and keyboard

schduler for AVR mcu

ti发布的MSP430 dco库 使用非常方便，非常稳定 -ti released MSP430 dco library is very convenient to use, very stable