在STM32中开关LED

基于ARM的I2C协议实现-I2C protocol

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.

用Keil C语言编写的EZ-USB CyC768013芯片 slave FIFO模式的固件程序-Keil C language using the EZ-USB CyC768013 chip slave FIFO mode firmware

arm7评估板eb40启动自检程序,ATMEL公司-arm7 Evaluation eb40 start self-inspection procedures, ATMEL Corporation

源码包含ccs5.1中sys/bios的使用，以及其中软中断相关设置。通过设置不同的优先级，设置多个软中断，观察c6713 cpu对软中断的管理。 包含两套源码！

用IAP实现的flash操作，此源码运行于LPC2131等开发板-IAP implemented with flash operation, the source code running on the LPC2131 development board, etc.

基于三星44b0的nandflash程序，包括基本操作-Based on Samsung 44b0 of the NANDFLASH procedures, including basic operation

基于AT89C51使用ADC0832进行模数转换和显示。使用proteus+keil，有仿真原理图和C程序。-Based on AT89C51 using the ADC0832 analog to digital conversion and display. Use proteus+ keil, a simulation schematic diagram and C programs.

protel yuanjianku zlg de lpc 2200 xilie

三星4510开发板Sdns100上代的演示程序-development board Sdns100 Not only the demo program