异步电动机矢量无速度传感器仿真模型,一起研究.

89s52+8255a控制一组指示灯循环发光-89s52+8255 a control cycle of a group of light emitting

一个单片机对EEPROM AT24C02的读写程序。绝对好用。-A single-chip EEPROM AT24C02 on reading and writing process. Absolute ease of use.

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

使用1520控制器的12232点阵液晶模块的51单片机控制C代码,keil编译通过,使用端口直接连接方法,P1口为数据口,控制线在P3部分端口-1520 controller using dot matrix LCD module 12232 51 C MCU control code keil compiled by the use of ports directly connected, I P1 for data export, the line of control in some ports P3

MDT单片机开发工具大全(267k)mdttool.zip-MDT MCU Development Tools Collection (267K) mdttool.zip

T6963为控制芯片的液晶驱动程序，带proteus方针。-For the control of the T6963 LCD driver chip, with Proteus approach.

C8051F的步进电机驱动程序。控制中的经典问题，值得一看-C8051F stepper motor driver. Control of the classic, eye-catcher

Program for ADC0808 with 4 bit LCD routine. It also includes Protus Debug file.

C51七种实用子程序集4-C51 seven practical subroutine Set 4

用51单片机驱动2.0TFT（S6D0128）。-with 51 Microprocessor 2.0TFT (S6D0128).