总测试程序，不仅可以测定其转速的信息，而且可以用于测定其报警信息的内容。可联合以上的程序进行调试。...

单片机智能抢答器设计论文，以及设计硬件图和附录-Single-chip intelligent design thesis Answer，And design the hardware chart and Appendix

1602A字符型小液晶4线驱动程序 第一次修改整理：2007.06.25 第二次修改整理：2007.07.20 基于ICCAVR开发环境 -1602A small character LCD Driver 4-wire finishing first modified: 2007.06.25 finishing second revision: 2007.07.20-based development environment ICCAVR

LT-1B msp430开发板例子程序－ADC12_-LT-1B msp430开发板例子程序－ADC12_11

本软件为7279显示控制器软件，用KEIL 7。0编写。-software for the 7279 display controller software, used KEIL 7. 0 prepared.

IC模块读写程序，经过很长时间使用，没出一点问题，目前看是非常不错的-IC module to read and write procedures used after a very long time, did not get out of difficulties, the current situation is very good

把单片机串口通讯改造为SPI通讯接口源程序，使用C51语言编写，可以用于MCS8051单片机-put microcontroller serial communications to transform SPI interface source, the use of C51 language, which can be used Mcs8051 MCU

基于AVR的USB单片机的源代码,其中部分代码被用在产品上.-based on the USB AVR microcontroller source code, part of which code was used in products.

KeilC51开发,51单片机与E2PROM的接口程序,并且有串口与液晶的输出.-KeilC51 development, SCM and 51 E2PROM interface procedures, and a serial port with LCD output.

本文档包括单片机系统中常用到的时钟中断、通讯及键盘扫描等模块(见所附源程序)的说明。这些模块使用前后台系统模型。为达到最大的灵活性, 需要在用户工程中定义config.h文件, 在其中定义各模块可选参数的设置，而不是直接更改源代码。-this document, including SCM system clock used to the interruption communications and keyboard scanning modules (see accompanying source code) Note. These modules use before and after the Taiwan model. To achieve maximum flexibility in user defined config.h engineering documents, in the definition module optional parameter settings, and not to directly change the source code.

ST7529为一32级灰度液晶显示屏驱动芯片，功能强大，耗电小．本程序为STC89LE58RC驱动ST7529整个工程包，程序的编绎环境为KEIL，本人保证程序绝对完整．-ST7529 is a 32 gray-scale LCD driver chip, powerful, small power consumption. This procedure for STC89LE58RC drive the whole project package ST7529, procedures for the provision Sounds of environmental KEIL, my absolute integrity assurance procedures.