CAN通讯 有源程序 很好 大家来看看 SJA1

自己写的 STM32 串口UART驱动, 不用固件库。超级终端界面按键时,自动回送。 应用范围: 因为不涉及IO口,所以此工程在STM32F1xx的任何主板上都可以运行。 编译器: IAR ARM 4.42A。 作者: w123456xy@sohu.com 15189792379。 -Write your own STM32 serial UART driver, no firmware library. HyperTerminal interface button, automatically send back. Application scope: because they do not involve IO port, so this works on any STM32F1xx motherboard can run. Compiler: IAR ARM 4.42A. Author: w123456xy@sohu.com 15189792379.

简易智能电动小车程序，寻迹、探测金属、寻光源、避障-Simple smart electric car program, tracing, detection of metal, look for light source, obstacle avoidance

一个很好的例程，希望对您有帮助，欢迎探讨

基于ADEK-PC实验系统多路温度信号（0~85℃）数据测量采集系统-based ADEK-PC experimental system of multi-channel temperature signal (0 ~ 85 C) measurement data acquisition system

利用多模式调制解调器芯片CMX868能直接通过高速串行总线与单片机串行接口进行通信这一特点设计的一套采用单片机来控制CMX868芯片的数据传输系统，握手协议部分-The use of multi-mode modem chip CMX868 directly by high-speed serial bus and the microcontroller serial interface to communicate with this feature set designed to use microcontroller to control the CMX868 chip data transmission system, part of the handshake protocol

9S12DT128B sci 模块介绍 英文-Introduction Module 9S12DT128B sci English

自己编写的专门针对6122红外编码芯片的红外解码程序,使用定时器+中断,占用CPU时间少,能稳定可靠的解码

msp430单片机控制输出PWM波,可以用来控制DC_DC变换用的控制信号,很好用-MSP430 single chip microcomputer to control the output PWM waves, can be used to control DC_DC transform the control signals used, very good use

用c语言实现对单片机端口的设置，已经调通，拿出来给大家分享-Use c language to realize single-chip port settings have been adjusted pass out to everyone to share

lcd1602液晶的avr测试实例程序，带proteus仿真。winavr 编译-lcd1602 LCD avr the test sample program, with proteus simulation. Winavr compiler