This code is related to the realization of the source code for USB functions, in...

这个范例说明如何使用8051 的Port 1连接LCD显示器，PORT 3.3、P3.4和P3.5则连接到LCD显示器的控制线。程序执行时将显示出Hello Keil C和LCD display */-This example shows how to use the 8051 Port 1 to connect LCD displays, PORT 3.3, P3.4 and P3.5 are connected to the LCD display control lines. Program execution will show Hello Keil C, and LCD display* /

这个SP2358外扩串口芯片的C语言源程序。非好好用。-Extend outside the SP2358 chip serial C language source code. Non-properly used.

LPC932内部EEPROM操作程序-LPC932 internal operating procedures EEPROM

51单片机硬盘控制电路以及原程序Demo，可用于CF卡等-51 microcontroller drives control circuit and the original procedure Demo can be used CF card

便携式压力传感器，带usb口和ic存储卡的-portable pressure sensors, with USB port and memory card ic

rc500 c语言库函数，对RC500的开发提供了捷径-rc500 c language library functions, the development of RC500 provides a shortcut

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

51单片机经典程序代码，扩展性，实用性极强，能用到各种模块中，热切的欢迎大家下载使用。-Classic 51 Single-chip code, scalable, highly practical, can be used in a variety of modules, fervent welcome to download.

该程序是单片机ATMEGA103通过GPIO口模拟SPI总线协议的SPI读写函数-The program is through the GPIO port ATMEGA103 Singlechip simulation SPI bus protocol of the SPI read and write function

单片机红外通信程序，实现单片机字符发送与接收的功能，支持ASCII码字符液晶显示功能-Single-chip infrared communication procedures, realize Singlechip characters send and receive functions, support for ASCII code character liquid crystal display function