I do on the boiler situation collection of products, including the original proc...

c51书籍，在最短时间内学会C语言和单片机。-C51 books, in the shortest possible time C language and Singlechip Society.

测试LPC2103的串口功能 打印出： program start here: new line new line-LPC2103 test print out the serial port function: program start here: new line new line

单片机温度控制系统-SCM temperature control system

用于驱动24L01芯片的函数代码，老外写的，很漂亮！-24L01 chip used to drive the function code, written by a foreigner, very beautiful!

主要是关于无线模块：nrf401和ptr200的资料-Mainly on the wireless module: nrf401 and ptr200 information

ADC0809是广泛使用的模／数转换器，在可不采用外部总线结构的单片机系统中(如 由AT89C51组成的系统)。ASC0809的数据线直接与单片结构的I／0 口相连，并由单片机的I／O 口直接对ADC0809进行控制。-ADC0809 is widely used in analog/digital converters, in not using the external bus architecture in the single-chip microcomputer system (such as the composition of the system by the AT89C51). ASC0809 data lines directly with the monolithic structure of I/0 I connected the MCU I/O port directly to control the ADC0809.

指纹识别，模块代码,算法，KEIL工程，可编译-Fingerprint Identification Module Code

这是一套基于单片机的温湿度测量系统，里边附有设计的原理图，pcb图，以及烧写程序代码（keil c51编写的）。温湿度传感器使用的是dht11，性价比高。该系统除了能显示温湿度以外，还能设置温湿度报警阈值。设计的pcb板，小巧，使用。这是本人的毕业设计，有实物为依据，具有可操作性。-This is a single-chip microcomputer-based measuring system of temperature and humidity inside with schematic design, pcb plans, as well as the programmer code (keil c51 prepared). Temperature and humidity sensors are used dht11, cost-effective. Except that the system can display temperature and humidity outside, but also set the temperature and humidity alarm threshold. Pcb board design, compact, use. This is my graduation project, there is the physical basis of operational.

嵌入式通用EEPROM读写程序.-embedded EEPROM read and write common procedures.

采用XC164CS的CAN系统解决方案，详细介绍了对TWINcan的开发套件-XC164CS using the CAN system solutions, detailed introduction on the development kit TwinCAN