AT89C52芯片的中文资料。包括内部结构，寄存器，及时序图

一个单片机控制无刷电机的代码程序-a brushless motor control microcontroller code procedures

这是一个串行通信接口的实例就是在单片机时钟频率在12MHz 波特率 9600bps 的通信方式下实现软件UART的发送程序。 -This is an example of serial communication interface is a single chip at 12MHz clock frequency in the communication baud rate of 9600bps software UART implementation of the send process.

c8051f 软件读出的FLASH数据转换成二进制数据-c8051f software FLASH read out data into binary data

一份51系列单片机的例程，里面包含了每个部分的代码，包括串口通讯，LCD，GPS数据接收处理，DA输出，EEPROM，USB读写等相关的代码。-A 51 series MCU routine, which includes every part of the code, including serial communications, LCD, GPS data receiving and processing, DA output, EEPROM, USB and other related reading and writing code.

单片机做的小键盘，单片机模拟ps2接口的程序-Singlechip make a small keyboard, single-chip analog interface procedures ps2

240128液晶显示的头文件,包括了字符显示子程序与点阵显示子程序-The first liquid crystal display 240,128 documents, including a character display with dot matrix display subroutine subprogram

基于MSP430F169的TS12864-5程序 可以显示汉字，字符，以及反白显示-Based on the MSP430F169 of TS12864-5 program can display Chinese characters, characters, and anti-white display

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

AVR mega8 单片机操作CC1100的例子-AVR mega8 MCU and CC1100 RF IC

c8051f020实现4个　产UART　口-C8051F020 realize four production UART port