MSP430f149上LCD显示的程序

自动升降电梯控制器设计 要求： 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则，并能响应提前关门延时关门，并具有超载报警和故障报警； 同时指示电梯运行情况和电梯内外请求信息。-Auto-Lift elevator controller design requirements: design of a six-story elevator controller. The controller can control the completion of six-story elevator containing the principle of giving priority customer service, and follow the directions, and can respond to close ahead of schedule delay closing, and has overload alarm and fault alarm also instructed the elevator and elevator operation request information both inside and outside.

无线收发程序MSP430主芯片 nrf模块-Program MSP430 main chip wireless transceiver module nrf

51单片机模拟2272解码,采用中断方法，精确判断同步码。-51 2272 microcontroller simulation decoding method used interruption, accurate judgment synchronous code.

上传一个arm调试软件，在xp下调试jtag经常出错，推荐使用该软件比较好用。-upload an arm debug software, under the xp JTAG Debugging often wrong, Suggested use the software more user friendly.

PLC中查表功能函数-PLC Lookup Function Function

IAR下，at91sam7s处理器，usb通信程序-IAR, at91sam7s processor, usb Communication Program

IAR开发平台下，at91sam7s下，I2C EPPROM驱动程序-IAR development platform, at91sam7s, I2C EPPROM Driver

ucos-ii 编译器ICCAVR CPU atmega8 8M 晶振 对原作者的ucos进行了简化，去掉了 hook，保留了基本功能 代码精简，编译后代码占 mage8 的 49% 时钟使用timer2，中断时间为2 ms 任务1：刷新LED，检测按键，调整时间 任务2：计时，串口发送 9600 bps--UCOS-II compiler ICCAVR. It simplifies original UCOS by removing hook, but it keeps basic functionality.

LCD ST7787 QVGA 屏 的 驱 动-LCD ST7787 QVGA screen driver

文件中包括了S3C2410基础试验源代码的触摸屏源代码-document S3C2410 including a pilot basis source code Touchscreen source code