LWIP 1.10 FOR UCOS

51单片机UCOS系统移植，包括全部源码，以及自己写的部分代码，编译通过(The 51 single-chip UCOS system transplantation, to including the the the all source code, as well as to write their own of the part of the code, the compiler through)

在ucos-ii下用LPC2290的spi端口驱动M65的液晶屏，可以任意开辟区域显示-Ucos-ii in the LPC2290 using the spi port driver M65 LCD screen, can open up the region show

研一的ucosii在s3c2440的移植源代码，有详细的移植说明，icosii版本：2.86。ads1.2下的mcp工程。使用ucosii及2440的朋友绝对不可错过。-Kenichi ucosii the S3C2440 transplant in the source code, a detailed description of the transplant, icosii Version: 2.86. ads1.2 works under the MCP. Ucosii and 2440 the use of friends should not be missed.

mc9328mx1在UCOS操作系统下的SSI原代码，这是微芯力的实验箱上的代码，均测试过。-uCOS mc9328mx1 in the SSI operating system source code, which is Chipscreen Experimental me on the code, were tested.

这是个介绍初入UCOS的程序员门，希望对你们有帮助。-This is a introduction uCOS programmers entering the door, hoping for your help.

买的430开发板的程序 uCOS-II与触控GUI(Buy 430 development board procedures uCOS-II and touch GUI)

uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器 uCOS-III实验_基于时间触发的混合式调度器

本文对ucgui配置文件进行了详细的说明。

uC/OS-II 在TI TMS320C240上的移植代码-Phone/OS-II in TI"s TMS320C240 transplant code

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)