设置下的C++语言的图形

这是Ganzalez书上的一个示例程序，用来实现直方图的线性运算处理。-This is a book Ganzalez sample procedures used for linear histogram processing.

A Survey of Techniques for Digital Watermarking

dwg源码C语言,对开发读取Auto Cad程序很有用途。-dwg resources for c,it is use for development of Auto Cad

比较容易理解的Gabor滤波代码，通过测试比较好用。-Relatively easy to understand Gabor filtering code, to pass the test comparing ease of use.

绘制三次样条曲线的vc程序，实用有效，需要的同志可以借鉴-drawing cubic spline curve vc procedures, practical and effective, it needs can learn from Comrade

图像灰度提升 注意：本程序中，每点击一次“增加亮度”，图像灰度提升16；每点击一次“降低亮度”，图像灰度降低16。-Grayhound upgrade Note : This procedure, each click "increasing brightness," Grayhound upgrade 16; Each click "lower brightness," Grayhound lower 16.

为了将零件固定在PCB上面，我们将它们的接脚直接焊在布线上。在最基本的PCB（单面板）上，零件都集中在其中一面，导线则都集中在另一面。这么一来我们就需要在板子上打洞，这样接脚才能穿过板子到另一面，所以零件的接脚是焊在另一面上的。因为如此，PCB的正反面分别被称为零件面（Component Side）与焊接面（Solder Side）。-parts to be fixed above the PCB, we will take their feet welded directly on the wiring. At its most basic PCB (single-panel), parts of which are concentrated in the side, wire were concentrated on the other side. Suppose we need burrows on the board, then through the legs of another plank, then parts of the legs is another welding in the face. Because of this, the PCB is negative components were known as surface (Component Side) and the welding surface (Solder Side).

C的图形处理程序,在 TC下调试通过.-C graphics processing procedures, the TC under debugging through.

alpha的演示，告诉大家如何用alpha-alpha demo to tell you how to use alpha

Visual C++ CAD应用程序开发技术源代码ch3-Visual C CAD application development technology source code CH3