c51单片机两个定时器使用，分别定时数码管的高低3位

uboot是一款优秀的嵌入式系统的bootloader程序。本软件包是uboot在ADI公司的blackfin533处理器上的移植。--Uboot is a good bootloader program for embedded system. This software package is a migration of uboot on ADI s blackfin533 CPU.

ARM9200在LINUX2.4.19下的时钟DS1337的驱动程序,可以直接加载使用-ARM9200 Now LINUX2.4.19 your DS1337钟时cavity cavity 驱 most序hung, you can直blames the weak floor, use the

AT91M5800a例子，很好用的！-AT91M5800a examples of good!

应用程序描绘了一个两路声音通讯在主和从之间，通过CC1110和TLV320AIC26芯片-This application note describes a two-way audio communications link between a ‘Master’ and a ‘Slave’, based on the Texas Instruments CC1110 or CC2510 Systemon-Chip Low Power RF Transceiver ([1]and [2]) and the TLV320AIC26 Codec [5]. Use is made of the μ-Law compression/expansion algorithm implemented in CC1110 (CC2510) hardware.

嵌入式linux打印机驱动EPSON系列-Embedded Linux printer driver EPSON Series

应用背景stm32 f207 can1can1stm32 f207 can1can1stm32 f207 can1can1关键技术 gpio nivc zhongduan stm32 can 配置 feichanfdfsf

本程序简单的示范了如何使用ATMEGA16的定时器 AVR定时器的要点介绍 T0工作于CTC模式，输出1KHz/2KHz 50％占空比的方波 T1工作于快速PWM模式兼输入捕捉 T2工作于相位修正PWM模式，输出490Hz的8bit PWM波-This procedure simple demonstration how to use the ATmega16 timers AVR timer T0 introduce the main points of work in CTC mode, the output 1KHz/2KHz 50 duty cycle square wave T1 work in fast PWM mode Input Capture and work on phase-corrected T2 PWM mode, the output of 8bit PWM wave 490Hz

nios 的开发程序，主要是针对LCD 的多口设计金额初始化-the development process is targeted mainly LCD design of the Multi-rate Initialization

S3C2410 ARM芯片内存管理单元MMU的实验基础和源代码

AT91SAM7S256-USB-CDC for IAR5