基于ucos的可移植的键盘程序。包含了四种键盘状态，按下，弹起，按下未弹起，重复。软件去抖的功能。...

ucos-II的shell开发，指示性代码，主要针对8051单片机，包括相关控件函数（转载）-CENTER-II shell development, indicative code, mainly aimed at 8051, including relevant control function (reproduced)

ucos-ii中互斥信号mutex的删除-ucos-ii in the deletion of mutex mutex signal

ucos 在 motloar 单片机上的移植(uCOS motloar Singlechip in the transplant)

在KEIL下使用UCOS来编写程式，还不错(in UCOS KEIL use to write programs, but also good)

自动对触摸屏幕进行校准，以十字标记为标准，方法简单，实用-Automatic touch screen calibration to cross markers as a standard, simple, practical

这是LM3S8962的完整的协议栈,在MKD3.20下可以直接运行-Please see it yourselfe

是基于stm32的ucos3 的例程，能够快速入门，帮助新人用的(A quick introduction to ucos3 to help newcomers)

ucos-ii for 2410 open source

uC_OS-II在Keil C上的移植代码，注意此代码使用与KeilV6.20及其以上版本。-Keil C portal of uC/OS-II source code. Note: this code is for Keil V6.20 or later version.

对于该开始学习嵌入式软件的人，采用phlip公司LPc系列芯片的人大有帮助。主要是完成的开发模板-began studying for the embedded software, the company used phlip LPc series chips NPC help. Main completed the development of a template