三相逆变器 180 传导

this is matlab program for turbo code set up.

数字图像处理matlab工具箱，包含彩色图像分割，RGB分量提取等基本源程序(Digital image processing toolbox matlab)

User manual of Kuka robot KR-30_60-3_KRC4

用于偏微分方程的三角剖分网格的网格生成器；

matlab编写的元胞自动机，最终的权值矩阵就是滤波器的系数，用于图像处理的独立分量分析，包括回归分析和概率统计，本科毕设要求参见标准测试模型，有借鉴意义哦。

相比于传统使用的电机，永磁同步电动机（PMSM）具有着比较高的工作效率、比较高的力矩惯量比、比较高的能量密度和环保节能等优越特性，所以对永磁同步电机进行控制调速方面的研究有着相当重要的意义。我们设定电机转速初始值作为给定值，然后与反馈的实际值进行比较，得到的差值输入PI控制器进行控制，得到交轴电流。同时三相绕组输出的电流经过clarke变换和park变化得到电流的实际值，分别与给定值进行比较，将比较后的值再进行park转换，得到的结果经过SVPWM技术调制之后输入到逆变器，继而可以驱动三相电机。(Used compared to traditional motor, permanent magnet synchronous motor (all-digital fuzzy) has a higher efficiency, higher moment of inertia ratio, higher energy density and superior properties such as environmental protection and energy saving, so the control of permanent magnet synchronous motor speed regulation research has important significance. We set the initial value of motor speed as the given value, and then compare it with the actual value of feedback. The difference obtained is input to PI controller for control, and the current of crossaxis is obtained. At the same time the output three-phase winding current through Clarke transformation and park changes the current actual value, compared with a given value respectively, after comparing the value of the park transformation again, the result after SVPWM modulation technology input to the inverter, which in turn can drive three-phase motor.)

基于NOMA的功率分配，采用树形算法，根据不同用户的信噪比大小，一定的约束关系，分配功率(NOMA power allocation based on the use of tree algorithm, depending on the size of the user' s SNR, certain constraints, power distribution)

免疫演算法求解TSP問題 包含了參數的設置並富有例題(Immune algorithm to solve TSP problem contains parameters to set up and full of examples)

solving assignment problem

本实验利用蒙特卡洛分析方法，通过MATLAB仿真了QPSK,16QAM基带传输系统AWGN和Rayleigh信道下的系统BER性能。仿真过程中通过，m文件的编写，将两个基带系统仿真的结果画在了一张图上(In this experiment, the BER performance of QPSK, 16QAM baseband transmission systems in AWGN and Rayleigh channels is simulated by using Monte Carlo analysis method and MATLAB. In the process of simulation, the simulation results of two baseband systems are drawn on a graph by compiling m files.)