MIPS BSP算法

An assembly to strobe the LEDsvia Port D. The strobe rate is to be set by adjusting the voltage drop over a potentiometer that is sampled by an ADC

基于s3c44b0x的ps2接口驱动程序-based on the ps2 s3c44b0x Driver Interface

野火3.5的库函数，可用于stm32函数开发，在单片机领域算是比较完备的了，一般购买开发板都会有，但是只是买最小系统板的话可以借鉴学习下

异步通信软件模拟, 异步通信软件模拟,异步通信软件模拟-asynchronism_communication_soft

STM32 开发板例子:SVC. 开发环境:Keil For ARM-STM32 development board example: SVC. Development Environment: Keil For ARM

USB通信源代码，适合LPC214X的USB开发。-USB communications source code for the USB development LPC214X.

sds SDN rf2401 22f sd2f dsfdsa公司

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

ARM cortex-M3系列处理器的代码，包括通用输入输出GPIO、模数比较器ADC、模拟比较器COMP。（IAR环境工程）-ARM cortex-M3 family of processors code, including general-purpose input-output GPIO, modulus comparator ADC, analog comparator COMP. (IAR Environmental Engineering)

本软件实现了FLASH底层驱动包括NOR FLASH与NAND FLASH-The software achieved a FLASH drive, including the bottom NOR FLASH and NAND FLASH