用SST89C58,对微型打印机和液晶的显示

51单片机的以太网 Ethernet 源程序和原理图-51 MCU Ethernet code and Schematics

根据示波器的原理最做的代存储和显示的简易装置-oscilloscope under the principle of doing the most generation storage and display of simple devices

利用C51和DS18B20进行温度读取，并在数码管上显示。-The use of C51 and DS18B20 temperature reading and digital tube display.

8051单片机矩阵键盘扫描程序（包括键盘的消抖和数码管的显示）-8051 keyboard matrix scanning process (including the elimination Buffeting keyboard and digital display control)

ATmega16数码管实验基数显示，数码管选通输出在前避免了字码在前产生的乱码，Proteus图-ATmega16 base of digital tube experiments showed that the digital control of strobe output of the former to avoid the code generated by the previous garbled, Proteus map

Freescale HC08GP32单片机接LCD源程序-Freescale MCU then HC08GP32 LCD source

LED扫描驱动程序，是16分之一扫描，包含多种模式，闪烁时间可调。-LED Scan driver, is one of 16 sub-scanning, contains a variety of patterns, adjustable flashing time.

DownLoad_sst39sf010.zip--嵌入式系统中关于SST39SF010的FLASH的BOOTLOADER源程序(KC51)-DownLoad_sst39sf010.zip--embedded system on the FLASH SST39SF010 source of BOOTLOADER (KC51)

能够将语音先进行录制，然后在回放，适合应用在一些需要语音播报功能的设备上-Able to carry out a voice recording, playback and then, suitable for broadcast in a number of the needs of voice-enabled devices on the

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high