use SPCE061A achieve input and, if necessary, can be properly cut

51单片机与PC机的串行通信中的程序原代码。-51 microcontroller and PC serial communication of program source code.

一个用于控制和读取GPS 系统的单片机程序。 所用的单片机是MICROCHIP 的PIC18F252-The singlechip program is used for controling and read GPS system.The singlechip is PIC18F252 of MICROCHIP

这是arm92440的脉宽调制（pwm） 适合初学者使用-Arm92440 This is the pulse width modulation (pwm) Suitable for beginners to use

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

我是用89S52做的模拟路灯控制系统。这个作品我在09年的全国大学生电子设计竞赛中获全国一等奖。-I used to do analog 89S52 lights control system. This work was in my 2009 National Undergraduate Electronic Design Contest won a national first prize.

是菲利普lpc2131AD调试程序，又详细的寄存器设置说明，在我的板子上调试过，对于初学者很不错。

这是一个实现串口通讯,发送与接收的源程序。用最简单的方法进行串口调试-This is a Serial communication, send and receive the source code. The simplest way to use serial port for debugging

这是一个简单的红外解码程序，是针对9ms起始码和4.5ms结束码的红外信号。晶振用的是11.0592M的，经测试能用。-This is a simple infrared decoding procedure is 9ms start code and end code 4.5ms infrared signal. 11.0592M crystal is used, and can be tested.

基于at89c2051的方波发生器，MAIN: MOV SP,#60H 设置SP指针 MOV R0,#50H 显示缓冲区首地址时50H ML0: CLR A MOV @R0,A 显示缓冲区清零 INC R0 CJNE R0,#55H,ML0-AT89C2051 based on the square-wave generator, MAIN: MOV SP,# 60H Set SP pointer MOV R0,# 50H shows that the first address buffer 50HML0: CLR A MOV @ R0, A display buffer cleared INC R0 CJNE R0,# 55H, ML0

单片机 c8051f06x 的中英文说明资料-c8051f060 datasheet